Tunturi FITRUN 90i PRO User Manual page 25

Hide thumbs Also See for FITRUN 90i PRO:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Safety key (Fig F-4)
The equipment is equipped with a safety key that must be properly
inserted into the console to start the equipment� If you remove the
safety key from the console, the equipment will stop immediately�
- Insert the safety key into the slot in the console�
- Make sure that the clip of the safety key is properly attached to
your clothing�
Make sure that the clip is not removed from your clothing before
the safety key is removed from the console�
Circuit breaker (Fig. E-2B)
The equipment is equipped with a circuit breaker that interrupts the
circuit when the electricity load is above the maximum capacity� When
this occurs, the circuit breaker must be pressed�
⚠ WARNING
Before pressing the circuit breaker, remove the mains plug from
the equipment�
If the equipment shuts down, proceed as follows to restart the
equipment:
- Remove the mains plug from the equipment�
- Press the circuit breaker to restart the equipment�
- Insert the mains plug into the equipment�
‼ NOTE
Some circuit breakers used in homes are not rated for high
inrush currents that can occur when a treadmill is first turned
on or even during normal use� If your treadmill is tripping the
circuit breaker (even though it is the proper current rating and
the treadmill is the only appliance on the circuit) but the circuit
breaker on the treadmill itself does not trip, you will need
to replace the breaker with a high inrush type� This is not a
warranty defect� This is a condition we as a manufacture have no
ability to control�
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1) and folded for
transport and storage (fig. F2).
Refer to the illustrations for the correct way of unfolding and folding
the equipment�
⚠ CAUTION
Before folding the equipment, make sure that the incline is 0%�
If the incline is not 0%, folding will damage the mechanism�
Console (fig. E-1)
⚠ CAUTION
Keep the console away from direct sunlight�
Dry the surface of the console when it is covered with drops of
sweat�
Do not lean on the console�
Only touch the display with the tip of your finger� Make sure that
your nails or sharp objects do not touch the display�
‼ NOTE
The console switches to standby Mode when the equipment is
not used for 10 minutes�
Press any key to wake up console again when being in standby
Mode�
External connections
USB port
Usb port can be used for charging purposes only�
AUX port
Aux port can be used to connect an external media device and play
music over the build in speakers�
‼ NOTE
The console can only be used as speaker system, and is not
able to use as media player� You need an extra device to use as
a media player such as a smart phone or tablet�
When using the console speakers it might result in HR reading
problems�
Buttons
Start
- Start selected workout�
- Restart Paused workout when being in pause mode�
Stop
- Stop the active training, and reset al parameters�
Pause
- Press to pause workout at any time. "PAU" will be displayed, and
runnign data will be saved�
Incline up
- Increases the incline (0~15 ± 0,5).
- Pressing and holding will increase the incline faster�
- Change values in programming mode.
Incline down
- Decreases the incline (0~15 ± 0,5).
- Pressing and holding will decrease the incline faster�
- Change values in programming mode.
Incline hot keys�
Incline Hot Keys are set as: 3, 5 & 7.
For example, the incline level changes from any level to 7 by pressing
the Incline Hot Key 7�
Speed up
- Increases the speed (0,8~20 km/h ±0,1km/h).
- Pressing and holding will increase the speed faster�
- Change values in programming mode.
Speed down
- Decreases the speed (0,8~20 km/h ±0,1km/h).
- Pressing and holding will decrease the speed faster�
- Change values in programming mode.
Speed hot keys:
Speed Hot Keys are set as: 6, 8 & 10 km/h.
For example, the speed changes from any speed to 8 KPH by
pressing the Speed Hot Key 8�
Mode
- Select Countdown program mode, Knowing:
Time Countdown
Distance Countdown
Calorie Countdown
Step Countdown
2 5
30:00
1:00
50.0
5000
English

Advertisement

Table of Contents
loading

This manual is also suitable for:

17tfrn9000

Table of Contents