Table of Contents
Advertisement
<Rear view>
Access indicator
(blinks when accessing)
Link indicator
(lit when linking)
Network connector
• Monitor out connector for adjustment
The video output is set to NTSC in the default settings of the camera. If you want to change the video output setting to
PAL, refer to the Operating Instructions on the provided CD-ROM.
• How to initialize the camera
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized. Note that the preset posi-
tion settings and the CRT key (SSL encryption key) used for the HTTPS protocol will not be initialized.
• Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may fail to initialize and may
cause malfunction.
Step 1
Turn off the power of the camera. When using a PoE hub,
disconnect the LAN cable from the camera. When using
an external power supply, disconnect the power cable
plug from the 12 V DC power supply terminal.
Step 2
Slide the SD memory card slot cover and check the posi-
tion of the INITIAL SET button.
12 V DC power supply terminal
External I/O terminals
Step 3
Turn on the power of the camera while holding down the
INITIAL SET button, and then keep holding down the but-
ton for around 5 seconds. The camera will start up and
the settings including the network settings will be initial-
ized.
Step 4
The live indicator will light orange → light off → blink
orange → light orange. It takes about 2 minutes for the
initialization to complete (when not connected to a net-
work).
(About the live indicator ☞ page 30)
Monitor out connector
for adjustment
Safety wire holder
Audio output connector
Microphone/line input connector
15
Advertisement
Table of Contents
