Panasonic DMR-UBC90 Operating Instructions Manual page 110

Messages on the front panel display
The following messages or service numbers
appear on the front panel display when something
unusual is detected.
CAM UPGRADE
CAM is being updated. (
CONVERSION
The picture quality of the selected programme
stored in the USB HDD is being changed.
Do not disconnect the USB HDD from this unit.
GUIDE
TV Guide data is being downloaded.
NO ERASE
You cannot delete items on this disc.
The disc may be damaged.
NO READ
• The disc is dirty. ( 28) The unit cannot record,
play, or edit.
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to
eject the disc.
PLEASE WAIT.
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
110
TQBS0033
84)
PROGRAMME FULL
• There are already 32 timer programmes. Delete
unnecessary timer programmes. (
• You are trying to divide a programme when the
maximum possible number of programmes is
already stored on the media.
REMOVE
The USB device is drawing too much power.
Remove the USB device.
SET CODE
("∑" stands for a number.)
The remote control and main unit are using
different codes. Change the code on the remote
control. ( 103)
START
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. ( 84)
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
UNSUPPORT
The media is not supported.
UPDATE /
("∑" stands for a number.)
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. ( 84)
U50
An error has occurred in the antenna's power
supply. Check to see if the antenna's cable core
and braided wire shield are in contact with each
other.
43)
84)