Panasonic DMR-UBC90 Operating Instructions Manual page 108

Edit
Cannot edit.
• You may not be able to edit on the HDD if there
is no available space. Delete any unwanted
programmes to create empty space. (
Photo
The contents of the SD card cannot be read.
• Remove the card from the slot and then insert
again. If this does not solve the problem, switch
the unit to standby mode and turn it on again.
Photos do not play back normally.
• The images that were edited on the PC, such as
Progressive JPEG, etc., may not play back.
( 26)
USB
This unit does not recognize the USB device
correctly.
• If inserted during playback the USB device may
not be recognized by this unit.
Disconnect and reconnect the USB device. If it
still does not recognize the connection, switch
the unit to standby mode and turn it on again.
• USB devices connected using a USB extension
cable other than a dedicated one or a USB hub
may not be recognized by this unit.
• Two USB devices cannot be used
simultaneously. If you insert a USB device while
watching TV, the USB device detection screen
is displayed. Use this screen to select the
device you want to use.
TV Guide
The TV Guide information is not displayed
properly.
• Set the clock correctly. (
• There was a programme change, or TV Guide
information from a broadcast station was
possibly not correctly transmitted.
• If signal quality is bad, the TV Guide system
may not be able to receive any data.
• It may take time until the TV Guide screen is
displayed correctly. Wait for about a day.
108
TQBS0033
60)
102, Clock)
Broadcast
Picture regularly breaks up on some
channels.
• Adjust the reception with "Manual Tuning".
( 89, 91)
The channel which was once selectable
cannot be selected.
• Reveal the channel on the channel list.
( 89, 91)
Digital broadcasts cannot be received.
• To receive an encrypted broadcast, a CI module
valid for the broadcast is required.
[UBS90]
• The dish may not be pointing in the direction of
the satellite. If problem persists consult your
local TV aerial installer.
• When you use only one terminal, you may not
view correctly if you connect the satellite cable
to the LNB IN 2 terminal.
• A wrong single cable version is set. Perform
Easy Setting again. (
[UBC90]
Major channels and favourite channels are not
displayed on the top part of the channel list.
• [DVB-C] To change channel allocation, restart
Auto Setup in Basic Settings menu and change
channel number allocation selection. (
• You can change channel number assignment.
( 89)
[UBC90] [DVB-T] [DVB-T2]
[UBS90]
Picture very infrequently breaks up on some
or all channels.
• Electrical atmospheric interference caused by
bad weather may cause pictures to break up
and audio to mute or distort momentarily.
22)
89)