CrimeStopper SP-202 Operating Instructions Manual page 5

Remote control alarm system
Hide thumbs Also See for SP-202:
Table of Contents

Advertisement

OPERATION INSTRUCTIONS
ARMING
To arm the alarm and lock the doors, press the Lock button on the transmitter. You will hear a single siren chirp
and the lights will flash once. The system will arm, the doors will lock and the starter will be disabled if these
optional features are installed. The red LED in the vehicle will start flashing after 5 seconds. After a short delay
to allow vehicle and electronics to stabilize the system will be completely armed.
DISARMING
Press the Unlock button on the transmitter to disarm the alarm. You will hear 2 siren chirps and the lights will
flash twice. The LED stops flashing. Door will unlock and dome light will turn on if the options are installed.
SELECTIVE SILENT ARM / DISARM THROUGH REMOTE CONTROL
This system can be armed and disarmed without siren chirps on an "as needed" basis. Press and release the
Silent Button for arm/disarm without siren chirps. The alarm system can be programmed to always Silently Arm
and Disarm with option number 1.
SELECTIVE ARM / DISARM with HORN HONK (programmable)
If the car horns are connected to the system, they can be set up to chirp (honk) with arm and disarm. The
default setting is to chirp with a double press of lock or unlock. This can be changed to chirp with a single press
by option # 3. Also the chirp pulse duration can be adjusted from short to long for quiet beep to a loud honk.
The choices are 15, 20 and 40 milliseconds.
PASSIVE ARMING MODE (Programmable)
Passive (automatic) Arming occurs 30 seconds after the ignition is turned off and the last door is closed. Upon
closing the last door, the unit will flash the lights twice and LED will be flashing rapidly to confirm passive
countdown. If a door is re-opened within the 30-second period, the countdown stops and begins again when
the door is closed. Passive arming provides failsafe protection in case you forget to arm the system.
PASSIVE ARMING with LOCK (Programmable)
The system can be programmed to passively lock the doors when the system passively arms or rearms. The
default setting is OFF because passive locking increases the risk of locking the keys in the vehicle when the
system arms/locks passively, without you pressing the remote.
5

Advertisement

Table of Contents
loading

Table of Contents