Iii-1-2 Connecting To Network; Iii-1-3 Starting The Web-Based Configuration Utility - Edimax GS-5654LX Quick Installation Manual

III-1-2 Connecting to Network
To connect the switch to the network:
1. Connect an Ethernet cable to the Ethernet port of a computer.
2. Connect the other end of the Ethernet cable to LAN Port of the switch.
The LED of the port lights if the device connected is active.
3. Connect an Ethernet cable to the IP Cameras
Connect the switch to end nodes using a standard Cat5e Ethernet cable to
connect the switch to end nodes as shown in the illustration below.
Switch ports will automatically adjust to the characteristics (MDI/MDI-X, speed,
duplex) of the device to which the switch is connected.
III-1-3 Starting the Web-based Configuration Utility
This section describes how to navigate the web-based switch configuration
utility.
Be sure to disable any pop-up blocker.
Browser Restrictions
 If you are using older versions of Internet Explorer, you cannot directly use
an IPv6 address to access the device. You can, however, use the DNS
(Domain Name System) server to create a domain name that contains the
IPv6 address, and then use that domain name in the address bar in place of
the IPv6 address.
Figure 8 - PC Connect
11