Replacing The Wi-Fi Units; Removing The Wi-Fi Adapter Card - Lenovo 10A4 Hardware Maintenance Manual

Figure 195. Installing the thermal sensor
10. Connect the cable of the new thermal sensor to the thermal sensor connector on the system board. See
"Locating parts on the system board" on page 81.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 224.

Replacing the Wi-Fi units

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
This section provides instructions on how to replace the Wi-Fi units. The Wi-Fi units include a Wi-Fi adapter
card, a Wi-Fi card module and a rear Wi-Fi antenna cable.
Replacing the Wi-Fi units includes the following operations:
• "Removing the Wi-Fi adapter card" on page 212
• "Removing the Wi-Fi card module" on page 214
• "Installing the Wi-Fi units" on page 215

Removing the Wi-Fi adapter card

To remove the Wi-Fi adapter card, do the following:
212
ThinkCentre M83 and M93/p Hardware Maintenance Manual