b. Lift the tab
1
upward as shown, and slide the new optical drive halfway into the bay from the front of
the computer. Then, release the tabs and continue to slide the optical drive into the bay until it snaps
into position.
Figure 13. Installing the optical drive
c. Connect the signal cable and the power cable to the new optical drive.
Note: Reconnect any cables removed from other supported devices.
Figure 14. Connecting cables to the optical drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 134.
Storage drive in the front-access storage enclosure
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
68
P520 User Guide