Table of Contents
Advertisement
Identifying Controls
Main unit
●
Slide the lever on the rear panel to eject the power
indicator and remote control sensor.
To store them, slide the same lever, or directly
push in the bottom surface of the remote control
sensor.
Note
●
For normal use, pull out the power indicator and
remote control sensor from the edge side of the
main unit by operating the lever on the rear panel.
Depending on the setup condition such as when
using the multi display, store them in the main unit.
1 Power Indicator / Remote control sensor
The Power Indicator will light.
When the power of the unit is ON (Main Power On
/ Off button: ON)
●
Picture is displayed: Green
●
Power OFF (standby) with remote control:
When [Network control] is set to [Off]: Red
•
When [Network control] is set to [On]: Orange
•
(Red/Green)
About [Network control] settings, see page 53.
●
Power OFF with "Power management" function:
Orange (Red/Green)
About "Power management" function, see page 47.
When the power of the unit is OFF (Main Power
On / Off button: OFF): No light
Note
●
Even if the display unit is turned off with the power
indicator off, some of the circuits are in power-on
status.
●
When the power indicator is orange, power
consumption during standby is generally larger than
that of when the power indicator is red.
1
8
INPUT
MENU
1 External Input Terminal
Connects to video equipment, PC, etc. (see page 16)
2 <Main Power On / Off button>
Turns the power On / Off.
3 <INPUT (Unit)>
Selects the connected device. (see page 28)
4 <MENU (Unit)>
Displays the menu screen. (see page 33)
5 <+ (Unit)> / <- (Unit)>
Adjusts the volume. (see page 29)
On the main screen, switches settings or adjusts
settings level. (see page 33)
6 <
(Unit)> / <
(Unit)>
Selects the setting item on menu screen. (see page
33)
7 <ENTER (Unit)>
Configures the item on menu screen. (see page 33)
Switches aspect mode. (see page 31)
8 Built-in speakers
Sound is output backward and upward.
Note
●
To output sound from the built-in speakers of the
unit, be sure to set [Output select] in the [Sound]
menu to [SPEAKERS]. (see page 37)
8
-
+
ENTER
English
25
Advertisement
Table of Contents
