Switching Off At The End Of The Season; Checking The Inner Components - Cadel IDRO PRINCE3 12 Installer Manual

Hide thumbs Also See for IDRO PRINCE3 12:
Table of Contents

Advertisement

15.13 SWITCHING OFF AT THE END OF THE SEASON

At the end of every season, before switching off the product, we recommend removing all the pellets from the hopper using a
vacuum with a long hose.
We recommend removing the unused pellets from the hopper because they can trap moisture. Disconnect any combustion air
ducts that can channel moisture into the combustion chamber, and above all, ask the specialised technician during the necessary
annual scheduled maintenance appointment at the end of the season to touch up the paint inside the combustion chamber with
specific silicone spray paints (that can be purchased at any retailer or customer service centre). This way, the paint will protect the
internal parts of the combustion chamber, preventing rust from forming.
When not in use, the appliance must be disconnected from the electrical mains. For greater safety, especially when
there are children, we recommend removing the power cable alltogether.
When turning the stove back on, if the control panel display does not turn on when you press the main switch on the side of the
product, it means you may need to replace the service fuse.
There is a fuse holder compartment on the back of the product, under the power plug. After having disconnected the plug from
the mains, use a screwdriver to open the fuse holder compartment cover and, if necessary, replace the fuses (3.15 A time delay).

15.14 CHECKING THE INNER COMPONENTS

ATTENTION!
Only qualified personnel with technical knowledge of combustion and electricity can check the inner electri-
cal-mechanical components.
.
PARTS/FREQUENCY
Brazier*
Ash pan
UNDER THE
USER'S
Glass
RESPONSIBILITY
Lower compartment
Turbulators
Complete heat exchanger
Smoke duct
Door gasket
Internal parts
Flue
RESPONSIBILITY
BY THE QUALI-
Circulation pump
FIED TECHNI-
CIAN
Plate heat exchanger
Plumbing components
Electro-mechanical components
Overpressure silicon damper for combustion chamber
Door closure operation
IDROSTUFE
2-3 DAYS
7 DAYS
1 YEAR
27

Advertisement

Table of Contents
loading

Table of Contents