Windshield Washer Fluid - Hummer 2007 H3 Owner's Manual

How to Check Power Steering Fluid
1. Turn the key off and let the engine
compartment cool down.
2. Wipe the cap and the top of the reservoir clean.
3. Unscrew the cap and wipe the dipstick with a
clean rag.
4. Replace the cap and completely tighten it.
5. Then remove the cap again and look at
the fluid level on the dipstick.
The level should be between the ADD and FULL
marks. If necessary, add only enough fluid to
bring the level up to the proper range.
What to Use
To determine what kind of fluid to use, see
Recommended Fluids and Lubricants on page 440.
Always use the proper fluid. Failure to use the
proper fluid can cause leaks and damage hoses
and seals.
346

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure
to read the manufacturer's instructions before
use. If you will be operating your vehicle in an area
where the temperature may fall below freezing,
use a fluid that has sufficient protection against
freezing.
Adding Washer Fluid
Open the cap with the
washer symbol on it.
Add washer fluid
until the tank is full. See
Engine Compartment
Overview on page 322
for reservoir location.