Programming Information
Programming the Scanner
To program the scanner, proceed as follows:
Ensure that the scanner is connected to the G-SITE or Passport system.
1
For the G-SITE systems, determine if the Back Office Pricebook software accepts/requires a
2
11-digit Expanded UPC recognition and/or Convert UPC-A to EAN-13 recognition.
Notes: 1) If Expanded UPC recognition is not required, do not scan
Scan the barcodes on
3
connected to a Passport system, skip
page 20
Emitting Diode (LED) will flash.
Sheet
1
2
3
4
5
6
7
8
9
10
*
Do not use if the scanner is connected to a Passport system. The Passport system requires default 9600 baud rate.
** Use only if Expanded UPC recognition is supported/required.
*** Use only if Convert UPC-A to EAN-13 recognition is supported/required. Not required for Passport systems.
**** Do not use if the scanner is connected to a Passport System running V20.04 or later.
If Expanded UPC recognition is required by the Back Office software, scan
4
page
If Convert UPC-A to EAN-13 recognition is required by the Back Office software, scan
5
"Sheet 16"
Note: This option is required for G-SITE systems that interface with Envoy BOS. This option
Scan
6
For G-SITE systems, cycle the console power before testing the scanner to ensure proper
7
operation.
~ OR ~
For Passport systems, stop and restart the Passport application using the System Maintenance
toolbar to ensure proper operation.
Page 8
if Convert UPC-A to EAN-13 recognition is not required, do not scan
page
35.
2) Envoy BOS requires Expanded UPC and Convert UPC-A to EAN-13 when
interfacing with G-SITE systems.
"Sheet 1"
to enter the configuration mode, the scanner will beep three times and the Light
Function
•
•
34.
on
page
35.
is not required for Passport systems.
"Sheet 18"
on
page 37
to exit the configuration mode. The scanner will beep three times.
MDE-4636C Honeywell® MS3780 Fusion Scanner Setup/Service Instructions · July 2021
on
page 20
to
"Sheet 11"
on
page
Function
11*
12
13****
14
15**
16***
17
18
19
"Sheet 16"
on
"Sheet 16"
page 37
in order (if the scanner is
30). After you scan
"Sheet 1"
"Sheet 15"
page
35;
on
on
on