Honeywell MS3780 Fusion Setup/Service Instructions page 7
Hide thumbs
Also See for MS3780 Fusion:
- Specification sheet (2 pages) ,
- Technical specifications (2 pages) ,
- User manual (52 pages)
Table of Contents
Advertisement
Programming Information
Important Programming Notes
• To program the Honeywell MS3780 Fusion Scanner, scan the barcodes found in this
manual from
• Expanded UPC recognition may not be available on all systems, or may require selecting
a specific option. Use the following guidelines:
Point of Sale
(POS) System Guidelines
G-SITE
Passport
MDE-4636C Honeywell® MS3780 Fusion Scanner Setup/Service Instructions · July 2021
"Sheet 1"
on
CAUTION
If the scanner is connected to a Passport system, do not scan
(2400 baud rate) or
"Sheet 16"
13"
on
page 32
with scanner connected to a Passport system will cause scanner
communication failure.
"Sheet 18"
CAUTION
If the G-SITE system does not interface with a Back Office System (BOS) that requires
Expanded Universal Product Code (UPC) recognition, do not scan
(Expand UPC-E to 12 digits). Scanning
does not interface with a BOS will cause the G-SITE system to lose all scanning ability.
CAUTION
If the G-SITE system does not interface with an Envoy
page 35
(Convert UPC-A to EAN-13). Scanning
system does not interface with an Envoy BOS will cause the G-SITE system to lose all
scanning ability.
The fusion scanner can be programmed for either Expanded 11-digit UPC recognition and/or
Convert UPC-A to EAN-13 recognition, if supported/required by Back Office software.
• If the Back Office software is not in use, do not enable Expanded UPC recognition or Convert
UPC-A to EAN-13 recognition.
• If Envoy Back Office software is in use, the Expanded 11-digit UPC recognition and Convert
UPC-A to EAN-13 recognition are required.
• If the Back Office software other than Envoy is in use, check with the Major Oil Company
(MOC) Help Desk or Back Office software vendor to determine if Expanded UPC recognition
and/or Convert UPC-A to EAN-13 recognition is supported/required.
To use Expanded UPC recognition, from Manager Workstation > Pricing > Items select Expand
UPCE option.
page 20
through
"Sheet 19"
on
page 35
(Convert UPC-A to EAN-13). Scanning
on
page 37
is for the G-SITE systems only.
"Sheet 16"
on
page 35
®
"Sheet 16"
Programming Information
on
page
38.
"Sheet 11"
on
page 30
"Sheet
"Sheet 15"
on
page 34
when the G-SITE system
BOS, do not scan
"Sheet 16"
on
page 35
when the G-SITE
Ensure that this option is
enabled (turned on)
on
Page 7
Hide quick links:
Advertisement
Table of Contents
