Honeywell MS3780 Fusion Setup/Service Instructions page 10

Fusion Scanner
Scan Pattern Mode Select Button
There are two configurable scan pattern modes available with the fusion scanner:
• The primary scan pattern mode is the default scan pattern that is active when the scanner
• The secondary scan pattern mode is activated by pressing the scan pattern mode button
Note: For information on changing the default scan pattern settings, refer to the MetroSelect
Changing Scan Pattern Modes
To change scan pattern modes, proceed as follows:
Press and release the mode select button, to activate the secondary scan pattern.
1
Figure 4: Changing Scan Pattern Modes
Note: Activating a pattern mode when the scanner is out of its stand does not change the
Press and release the mode select button again, to reactivate the primary scan pattern.
2
Page 10
starts. By default, the primary scan pattern is set to all-scan-lines for omnidirectional
reading.
(see Figure 4). By default, the secondary scan pattern is set to single-line mode for menu
reading.
Configuration Guide.
in-stand pattern mode. When the scanner is returned to the stand, it will automatically
revert to the most recent scan pattern selected during an in-stand operation.
MDE-4636C Honeywell® MS3780 Fusion Scanner Setup/Service Instructions · July 2021
®
