Advertisement
HBH-660/-662
1.
Make sure that the headset is fully charged, switched on and within 1 m (3 ft) of the phone.
2.
The first time you turn your headset on, it immediately goes into pairing mode.
There are three symbols showing in the headset display: a headset, two rotating arrows and a phone.
Proceed to phone instructions below.
3.
To manually prepare the headset in paring mode, press the VOLUME BUTTONS, (+) and (-), at the same time for
approximately 5 seconds, until your hear a long high frequent beep. There are three symbols showing the headset
display: a headset, two rotating arrows and a phone. The headset is now in "Pairing mode".
P910
1.
In the Application view, tap on CONTROL PANEL, CONNECTIONS tab, BLUETOOTH.
2.
Tap the SETTINGS tab and set Bluetooth to ON.
3.
Select the DEVICES tab and press ADD.
4.
The phone starts searching for Bluetooth devices. Make sure that the headset is in pairing mode
5.
When the HBH-xxx becomes visible in the AVAILABLE DEVICES menu, tap it.
6.
Enter the PASSKEY (0000 by default) and press DONE. On the screen, BONDING COMPLETED appears.
7.
Tap DONE and HBH-xxx is added to the list of Bluetooth devices and is ready to use.
Rev
2
R1g
Advertisement
