Yamaha RS Venture RST90Y Owner's Manual page 30

Control functions
1. 2-up position (rider and passenger)
2. Solo rider position
3. Special tool
4. Lock pin
2. Pull the lock pin and turn the special tools
to change the block position.
3. Release the lock pin.
4. Remove the special tools from the 2-up
adjusting block.
ESU11033
Adjusting the control rods
EWS00770
WARNING
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
The weight transfer can be adjusted by turn-
ing the adjusting nuts on the control rods.
1. Loosen the locknut while holding the ad-
justing nut.
24
1. Locknut
2. Control rod adjusting nut
2. To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
ting, indicated by red paint; otherwise,
they could be damaged, which could
lead to an accident or injury.
[EWS00173]