Valve Clearance; Engine Oil And Oil Filter Cartridge - Yamaha RS Venture RST90Y Owner's Manual

Periodic maintenance and adjustment
sult a Yamaha dealer. The dealer can tell you
if there are any changes necessary for the al-
titude where you plan to ride. NOTICE: The
drive chain gears and V-belt clutch should
be adjusted when operating above a high
altitude of 900 m (3000 ft). Consult a
Yamaha dealer.
[ECS00431]
ESU11950

Valve clearance

The valve clearance changes with use, result-
ing in improper air-fuel mixture and/or engine
noise. To prevent this from occurring, the
valve clearance must be adjusted by a
Yamaha dealer at the intervals specified in
the periodic maintenance chart.
ESU11975

Engine oil and oil filter cartridge

The engine oil level should be checked before
each use. In addition, the oil must be changed
and the oil filter cartridge replaced at the inter-
vals specified in the periodic maintenance
and lubrication chart.
EWS00370
WARNING
Engine oil is extremely hot immediately af-
ter the engine is turned off. Coming into
contact with or getting any engine oil on
your clothes could result in burns.
ECS00480
NOTICE
Do not run the engine with too much or
G
not enough oil in the oil tank. Oil could
spray out or the engine could be dam-
aged.
Be sure to change the engine oil after
G
the first 800 km (500 mi) of operation,
and every 4000 km (2500 mi) thereafter
or at the start of a new season, other-
wise the engine will wear quickly.
The oil filter cartridge should be re-
G
placed every 20000 km (12000 mi) of op-
eration.
44
To check the engine oil level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Start the engine, warm it up for 10–15
minutes, and then turn it off.
TIP
The engine can also be warmed up by op-
G
erating the snowmobile for 10–15 minutes.
After operating the snowmobile, allow the
G
engine to idle for at least 10 seconds before
turning it off.
3. Open the shroud.
4. Disconnect the oil level gauge coupler.
NOTICE: Disconnect the oil level
gauge coupler before removing the oil
filler cap, otherwise the cable could
twist and break.
1. Oil level gauge coupler
2. Oil filler cap
[ECS00452]