Table of Contents
Advertisement
System expansions
Removing the drive cage
Ê
Open the workstation (see "Opening the workstation").
Ê
Pull the data and power supply connectors from the hard disk drive(s).
1
Ê
Undo the screw (1).
The temperature sensor is attached to the drive cage. During the installation, you will have to attach
the temperature sensor again.
Ê
Pull the drive cage out of the casing in the direction of the arrow (2).
Installing a hard disk drive
Ê
Take the new hard disk drive out of its packaging.
Ê
Make the required settings (e.g. master-slave settings) on the drive.
2
2
1
44 - English
Ê
Ê
2
2
Installing and removing hard disk drives
Slide the hard disk drive into the drive
cage (1).
Fasten the drive into place with the
screws (2).
A26361-K547-Z400-1-7419
Advertisement
Table of Contents
