Push the accessible drive into the casing (1) until the EasyChange rails engage.
Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
Close the casing (see "Closing the casing" chapter).
It may be necessary to modify the entry for the drive in the BIOS Setup.
I Removing an accessible drive
Open the casing (see "Opening the casing" chapter).
Pull the data and the power supply connectors from the desired drive.
Press the EasyChange rails together (1) and pull the drive out of the casing (2).
If necessary, make the required settings on the remaining hard disk drive.
1
1
1
2
37