Transporting The Workstation; Cleaning The Workstation - Fujitsu Siemens CELSIUS 4 Series Operating Manual

Transporting the workstation

·
Reorient or relocate the receiving antenna.
·
Increase the separation between equipment and the receiver.
·
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
·
Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Siemens Computers GmbH is not responsible for any radio or television interference caused
by unauthorised modifications of this equipment or the substitution or attachment of connecting
cables and equipment other than those specified by Fujitsu Siemens Computers GmbH. The
correction of interference caused by such unauthorised modification, substitution or attachment will
be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC rules.
Transporting the workstation
Transport all parts separately in their original packaging or in a packaging which protects
!
them from knocks and jolts, to the new site. Do not unpack them until all transportation
manoeuvres are completed.
Never drop the monitor (risk of implosion)!

Cleaning the workstation

Turn off all power and equipment switches and pull the power plug out of the grounded
!
mains outlets.
The inside of the workstation casing may only be cleaned by authorised, specially trained
personnel.
Do not use any cleaning agents that contain abrasives or may corrode plastic.
Ensure that no liquid enters the system.
Ensure that the ventilation areas of the workstation and the monitor are free.
Cleaning the workstation and the monitor
Wipe the workstation and monitor casing with a dry cloth. If particularly dirty, use a cloth that has
been moistened in mild domestic detergent and then carefully wrung out.
Cleaning the keyboard and the mouse
Use disinfectant wipes to clean the keyboard and the mouse.
The mouse mechanism and the mouse ball can be cleaned by removing the retaining ring on the
underside of the mouse.
Ê
Using two fingers push the retaining ring and turn the ring in the direction of the arrows.
Ê
Remove the retaining ring and the rotating ball.
Ê
Clean the ball and the three small wheels in the mouse with a lint-free cloth.
Ê
Replace the ball and the retaining ring.
Ê
Using two fingers, push the retaining ring and turn the ring in the opposite direction of the
arrows. You should feel the ring engage.
A26361-K547-Z400-1-7419
Important notes
English - 5