Table of Contents
Advertisement
Switching the workstation on and off
Switching the workstation on
Ê
Switch the monitor on (see the operating manual for the monitor).
Ê
Switch the workstation on with the main switch at the rear of the workstation.
Ê
Press the ON/OFF switch on the front of the workstation.
The power-on indicator lights green, the workstation is started.
If you have assigned the system password, you must enter this when requested to do so
i
in order to start the operating system.
Switching off the workstation
Ê
Shut down the operating system properly. Windows in the Start menu via the Quit function.
Ê
If the operating system does not automatically switch the workstation off, switch the
workstation to ready-to-operate by pressing the ON/OFF switch or turn it off by pressing the
main switch when requested to do so.
If the workstation is ready-to-operate the workstation consumes a minimum of energy and can be
switched on by an external device (provided that the remote-on functionality is set to Enabled in the
BIOS Setup).
If you use the main switch to switch off the workstation, it uses no power.
The main switch and the ON/OFF switch do not disconnect the workstation from the
i
mains voltage. To completely disconnect the mains voltage, remove the power plug from
the socket.
Placing a workstation (with soft power off function) in a ready-to-operate state by means of
software
With the soft power off function the workstation automatically switches off (standby) or switches into
the energy-saving mode after the operating system is shut down. Requirements: Your system must
support switching off with software and this functionality must be enabled in BIOS Setup. The soft
power off software may also need to be installed on Windows NT systems.
You can also switch your workstation into the standby mode via the DeskView software with the
DeskOff component.
A26361-K547-Z400-1-7419
Preparation for use and operation
English - 17
Advertisement
Table of Contents
