Table of Contents
Advertisement
Shooting with the DSR-1/1P
4
Release the REV or FWD button when you find
the tape location where you wish to continue
shooting.
The DSR-1/1P enters recording pause mode.
5
Press the VTR button on the camera head or the
lens.
The DSR-1/1P starts recording.
Using the Freeze Mix Function
The freeze mix function superimposes a freeze-frame
image of a previously recorded shot on the shooting
image displayed on the viewfinder screen.
You can use this function to easily frame a subject
within the same framework from a previous shot.
Note
When the camera head is in EZ mode, the freeze mix
function is disabled. Release the EZ mode beforehand.
(See page 12.)
1
Dock the DSR-1/1P to the camera head and
connect a color monitor to the MONITOR OUT
connector.
2
Perform steps 2 to 10 from "Basic Procedure for
Shooting" (page 39).
3
Access basic menu page 7 and move the cursor to
FREEZE.
For details of menu operations, see "Basic Menu
Operations" (page 51).
MARK/CUE:MARK
mFREEZE:OFF
CHG REEL NO:
(YES m4)
44
Chapter 3 Shooting
4
Play back the tape on which the image to be used
for framework alignment has been recorded.
For details of the playback operation, see the operating
instructions for the DSR-1/1P.
A color playback image is displayed on the color
monitor's screen.
5
Press the UP/ON button when you see the image
you want to freeze.
The frozen playback image is displayed, mixed
with the shooting image, in monochrome. The
indication "FREEZE MIX ON" appears on the
screen.
To change the freeze-frame image
Press the DSR-1/1P's PLAY button.
This returns to the screen shown in step 3 above,
and color playback mode begins.
Use the DSR-1/1P's tape transport buttons to find
the desired image and then perform step 5 again.
6
Once you have framed your subject, press the UP/
ON button to cancel the freeze function.
This returns to the screen shown in step 3.
7
Find the recording start point or insert a new
cassette for recording, then begin recording.
Note
If you use the DSR-1/1P's tape transport buttons
during back space editing, the back space editing mode
will be stopped. When you were using the ClipLink
function when shooting, If you simply restart the
recording you will lose any ClipLink data that was
recorded. To avoid this, press the DSR-1/1P's
ClipLink CONTINUE button before restarting
recording.
For details, see the operating instructions for the DSR-1/1P.
Advertisement
Table of Contents
