Programming; To Add A Remote Control, Keypad, Or Myq; Myq ® Enabled Accessories - Chamberlain RJO20 Manual

Programming

Your hand-held remote control (model 953ESTD) has already programmed to the door control (myQ
at the factory. Below are instructions for programming additional remote controls, keypads, and myQ
accessories to the door control.
NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door
opener will NOT program accessories.

To Add a Remote Control, Keypad, or myQ

REMOTE CONTROL
®
1. Press the myQ Control Panel LEARN button twice,
the red learn LED will turn on.
2. Press the button on the remote control that you
wish to operate your garage door.
3. The garage door opener lights will flash (or two
clicks will be heard) when the code has been
programmed.
®
myQ ENABLED ACCESSORIES
®
1. Press the myQ
twice, the red learn LED will turn on.
2. Press the LEARN button on the myQ
LEARN
Button
Model PILCEV - Remote Light Control
Light module can be synchronized with the garage
door opener light bulbs.
Control Panel LEARN button
®
device.*
® Enabled Accessories
KEYPAD
1. Press the myQ
red learn LED will turn on.
2. Enter a 4-digit personal identification number (PIN) of
your choice on the keypad. Then press the ENTER
button.
3. The garage door opener lights will flash (or two clicks
will be heard) when the code has been programmed.
Command
LED (yellow)
Learn LED
(Red)
Model WSLCEV - Remote Light Switch
Light module can be synchronized with the garage
door opener light bulbs.
®
* myQ accessories may be programmed to the
Chamberlain ® Internet Gateway (Model 828LG) or
®
the myQ Control Panel.
29
® Control Panel)
® enabled
®
Control Panel LEARN button twice, the
? ?
PIN
? ?
LEARN
Button