Using The Door Control (Myq ® Control Panel) - Chamberlain RJO20 Manual

Operation
(continued)
Using the Door Control (myQ
NOTE: Due to power consumption, this door control (Model 041A7928-3) cannot be used in conjunction with another
wired door control connected to your garage door opener. If an additional door control is needed, the wireless door
control model 041A7773-1 can be programmed to the door control (Model 041A7928-3). To program the 041A7773-1
to the myQ ® Control Panel, follow the remote control programming steps.
10 Minute TTC LED
FEATURE
PUSH BAR
LOCK
Designed to prevent operation of the door from hand-held
remote controls. However, the door will open and close
from the Door Control, keypad, and myQ
MOTION SENSOR
This feature will automatically turn on the garage door
opener lights when motion is sensed. The lights will come
on for 4-1/2 minutes, then shut off.
TIMER-TO-CLOSE (TTC)
The TTC feature automatically closes the door after a
specifi ed time period (1, 5, or 10 minutes). Once the
TTC has been set and the door is open, the LED for the
selected close interval will blink and begin to count down
to close the door. The control panel will beep and the
garage door opener lights will fl ash before closing the
door.
The TTC feature will deactivate if the garage door
encounters an obstruction twice; or the safety reversing
sensors are incorrectly installed. The garage door will
reverse open and WILL NOT close until the obstructions
are clear or the safety reversing sensors are correctly
installed. When the obstruction has been cleared or the
safety reversing sensors have been aligned, the door will
close when the garage door opener is activated
® Control Panel)
Push Bar
1 Minute TTC LED
5 Minute TTC LED
® App.
HOLD OPEN Button for the Timer-
To-Close (TTC)
LIGHT Button
Motion Sensor
HOW TO:
Press the push bar to open/close the door.
Activate: Press and hold the LOCK button for 2
seconds. The command LED will fl ash as long as the
lock feature is activated and your handheld remote
control will not operate your door at this time.
Deactivate: Press and hold the LOCK button again for
2 seconds. The command LED will stop fl ashing and
normal operation will resume.
Activate/Deactivate:
Slide the motion sensor switch ON or OFF.
Activate: Press and hold the ON button until one of
the TTC LEDs light up. Then press the ON button
again to cycle through the time interval options
(the corresponding TTC LED will light for each time
interval). The garage door opener light bulbs will blink
as confi rmation.
Deactivate: Press and hold the OFF button until all TTC
LEDs turn off and a beep is heard from the control panel.
To suspend the TTC: To suspend the TTC and
temporarily hold the door open, press and release the
HOLD OPEN button (the HOLD OPEN LED will turn
solid). The TTC will remain suspended until the HOLD
OPEN button is pressed again or the garage door opener
is activated from another device (door control, remote
control, keypad, etc.).
27