Canadian Programming; Resetting Defaults - Chevrolet 2002 Impala Owner's Manual

Canadian Programming

Canadian Owners: During programming, the hand
transmitter may automatically stop transmitting after
two seconds. In this case, you should press and hold
the HomeLink button (see Steps 2 and 3 under
"Programming the HomeLink Transmitter") while you
-
press and re press (cycle) your hand
every two seconds until HomeLink is trained.
Operating the HomeLink Transmitter
Press and hold the appropriate button on HomeLink for
at least half of a second. The indicator light will come
on while the signal is being transmitted.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.
-
held
-
held transmitter

Resetting Defaults

To reset HomeLink to default settings, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Continue to hold both
buttons until the HomeLink indicator light turns off and
then release both buttons.
Accessories
Accessories for the HomeLink Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please contact the manufacturer
- -
of HomeLink at 1 800 355
at www.homelink.com.
-
3515, or on the internet
2-77