Gate Operator And Canadian Programming - Chevrolet 2003 Avalanche Owner's Manual

If the indicator light stays on constantly, programming
is complete and your device should activate when the
®
HomeLink button is pressed and released.
To program the remaining two HomeLink
begin with Step 2 under "Programming HomeLink
Do not repeat Step 1 as this will erase all of the
programmed channels.
If the indicator light blinks rapidly for two seconds
and then turns to a constant light, continue with
Steps 6 through 8 following to complete the
programming of a rolling-code equipped device
(most commonly, a garage door opener).
6. Locate in the garage, the garage door opener
receiver (motor-head unit). Locate the "Learn"
or "Smart" button. This can usually be found where
the hanging antenna wire is attached to the
motor-head unit.
7. Firmly press and release the "Learn" or "Smart"
button. The name and color of the button may
vary by manufacturer.
You will have 30 seconds to start Step 8.
8. Return to the vehicle. Firmly press and hold the
programmed HomeLink
then release. Repeat the press/hold/release
sequence a second time, and depending on the
brand of the garage door opener (or other rolling
code device), repeat this sequence a third time
to complete the programming.
®
buttons,
®
button for two seconds,
®
HomeLink should now activate your rolling-code
equipped device.
To program the remaining two HomeLink
begin with Step 2 of "Programming HomeLink
®
."
repeat Step 1.
Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to "time out" or quit after several seconds of
transmission. This may not be long enough for
®
HomeLink to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured to
"time out" in the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator by using the
"Programming HomeLink
where you live), replace Step 3 under "Programming
®
HomeLink " with the following:
Continue to press and hold the HomeLink
you press and release every two seconds (cycle) your
hand-held transmitter until the frequency signal has been
successfully accepted by HomeLink
will flash slowly at first and then rapidly. Proceed with
Step 4 under "Programming HomeLink
®
buttons,
®
." Do not
®
" procedures (regardless of
®
button while
®
. The indicator light
®
" to complete.
2-57