Panasonic PressIT TY-WPS1W Operating Instructions (Functional Manual) page 39

●
Input signal display (When receiver board input is selected)
Displays the frequencies of the signal currently being input, and the type of signal.
H-freq.
33.72
V-freq.
60.00
Dot clock freq.
74.18
Signal format
1080/60i
HDCP status None
When receiver board input (SLOT) is selected, the following information is displayed.
• When the image of the transmitter is displayed, the information of image signal input to the transmitter is
displayed.
• When the image of the transmitter is not displayed (standby screen is displayed), the information of signal output
from the receiver board is displayed.
Panasonic display link function
Just connect the receiver to a Panasonic display supporting this product using HDMI cable and turn
them on to perform the link operation. (It is necessary to set [Wireless presentation link] to [On].)
Set link function details in the following setting menus.
■
Power on settings
Makes various settings at power-on.
[Power on settings] - submenu screen
Power on settings
Initial input
Initial startup Last memory
Initial VOL function
Initial VOL level 0
Power ON screen delay
Information(No activity power off)
Information(Power management)
Information(Display upside-down)
Quick start
●
[Quick start]
This function quickly turns the power on at power-on.
[Off]:
Turns the power on in a usual manner at power-on.
[On]:
Quickly turns the power on at power-on.
Note
• When this function is set to [On], power consumption is increased in standby mode.
• When this setting is set to [On], the power indicator in standby mode lights in orange (red/green).
• When supplying power to the receiver from the USB terminal of the display, set this to [On].
kHz
Hz
MHz
Off
Off
Off
Off
Off
Off
Off
English 39 39