Panasonic PressIT TY-WPS1W Operating Instructions (Functional Manual) page 15

3
Using the screw removed in step 1, fix the receiver board to the SLOT adaptor.
●
Tightening torque guideline: 0.5 N·m or less
Note
●
Firmly tighten the screw, and check that the hook of the SLOT adaptor fixes the circuit board.
●
Check that the surface of the SLOT adaptor and the surface of the circuit board match with each other when the
receiver board with the SLOT adaptor attached is viewed from the opposite side of the cover.
Make sure that this side is aligned.
Circuit board
●
If there is a lead wire within approx. 3 mm from the end face of the circuit board, the receiver board cannot be
attached due to interference with the guide rail. Ensure that there is no lead wire in this range.
Circuit board
Screw
SLOT adaptor
Approx. 3 mm
No lead wire in this range.
× ×
It cannot be attached unless this side is horizontally
aligned.
× ×
English 15 15