Chevrolet 1998 Tracker Owner's Manual page 104

Removing and Installing the Side Window
1. Unfasten the Velcro@ strips on the top and rear
quarter of the side window.
2. Unzip the zipper almost all the way, leaving about
3 inches (8 cm) of it still zipped and unfasten the
Velcro strips on the inside of the window.
3. Release the plastic strip sewn along the bottom edge
of
the window by gently pulling down and out. Then
release the plastic along the front edge of the
window by pulling it forward and out.
4. Unzip the zipper the rest of the way and remove the
side window.
Reverse the steps to install the side window.
During installation you may want to start by zipping the
zipper about 3 inches (8 cm), to hold the window in
place. When zipping, place the rear bottom corner of the
window inside the rear part of the vehicle body to help
you engage the zipper end.
2-45