Table of Contents
Advertisement
Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake or clutch pedal. This, of
course, disengages the cruise control. But you don't
need to reset it.
Once you're going about 25 mph (40
k m / h )
or more,
you can move the cruise control switch to FUA
(Resume/Accelerate) for about half a second. The DIC
will display the cruise set speed.
You'll go right back up to your chosen speed and stay there.
Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed:
1. Use the accelerator pedal to get to the higher speed.
The speed will not begin to increase until sufficient
pedal travel is achieved. Push the button at the end of
2.
ihe lever, then release the button and the accelerator
pedal. You'll now cruise at the higher speed.
The DIC will display the cruise set speed.
Move the cruise switch to FUA. Hold it there until
you get up to the speed you want, then release the
switch. To increase your speed in very small
amounts, move the switch to R/A for less than half
a second, then release it. Each time you do this,
your vehicle will go about 1 mph (1.6
k m k )
faster.
The DIC will display the cruise set speed.
2-49
Advertisement
Table of Contents
