Chevrolet 1994 Astro Passenger Owner's Manual page 236

10. Remove the two
screws at the
engine cover
using a long
handled
screwdriver. The
screws are not
supposed to come
out of the cover,
only from the
front of dash.
When removing the cover, be careful not to damage the instrument panel or
the trim.
11. Grasp the bottom
of the cover and
slide it
backwards. Then,
lift it up and out
of the vehicle.
To Install the Engine Cover:
1. Lift the engine cover into the vehicle and slide it all the way forward.
Make sure the rubber seal is over the latches.
2. Install the two screws at the engine cover. Do not tighten the screws all
the way.
3. Press down on each of the two latches at the bottom of the cover. Make
sure they are secure.
4. Tighten the two screws at the engine cover.
5. Turn the bracket into position and install
the
bolt. Tighten the nut at the
other end of the bracket.
6. Put
the
heater duct over the engine cover studs. Push up on the duct
gently until it snaps into place.
7. Reconnect the electrical connector for the cigarette lighter.
6 - 18