Engine Overheating - Cadillac 2010 DTS Owner's Manual

Hide thumbs Also See for 2010 DTS:
Table of Contents

Advertisement

4.6L L37 Engine shown, 4.6L LD8 Engine similar
4. With the coolant surge tank cap off, start the engine
and let it run until you can feel the upper radiator
hose getting hot. Watch out for the engine
cooling fans.
By this time, the coolant level inside the coolant
surge tank may be lower. If the level is lower, add
more of the proper mixture to the coolant surge tank
until the level reaches the FULL COLD mark on
the side of the coolant surge tank.
5. Replace the cap. Be sure the cap is hand-tight and
fully seated.
Notice: If the pressure cap is not tightly installed,
coolant loss and possible engine damage may
occur. Be sure the cap is properly and tightly
secured.
If coolant is needed, add the proper DEX-COOL
coolant mixture at the coolant recovery tank.

Engine Overheating

The vehicle has several indicators to warn of engine
overheating.
There is an engine temperature warning light and/or
gage on the instrument panel cluster. See Engine
Coolant Temperature Warning Light on page 4-55 and
Engine Coolant Temperature Gage on page 4-56.
The vehicle may also display a ENGINE OVERHEATED
IDLE ENGINE message or an ENGINE OVERHEATED
STOP ENGINE message displayed in the Driver
Information Center (DIC). See DIC Warnings and
Messages on page 4-67 for more information. You will
also hear a chime.
®
6-27

Advertisement

Table of Contents
loading

Table of Contents