Husqvarna PG 530 Workshop Manual page 25

Fitting on satellite motor and pulleys
FITTING THE FLY PULLEY ASSEMBLIES
Use a high temperature grease as bearing lubricator.
6mm
1. Apply a thin layer of grease to the con-
tact surfaces:
(a) Around the bearing outside.
(b) Inside the cast pulley bearing hous-
ing.
• Place the fly pulley assembly in the
bearing housing.
2. Repeat the steps in (1) until all the three
satellite pulleys are mounted.
• Be sure not to have excess grease on
the pulley as this will become ex-
posed to the belt.
MOUNT THE BELT TENSIONING
ASSEMBLY
3. Use two Allen keys to mount the ten-
sion pulley assembly with two bolts in
the tensioning bracket.
4. Fit on the washer on the tensioning
bolt.
5. Lower the belt tensioning assembly into
position and fit the bolt through the po-
sitioning hole.
6. The belt tensioning assembly in posi-
tion.
12
23