Dismantling Into Basic Modules - Husqvarna PG 530 Workshop Manual

5

5.Dismantling into basic modules

8
Dismantling into basic modules
×2
×4 13mm
Basic modules
This chapter shows how the machine is built
up of basic modules, for example, the
chassis / frame unit and the grinding unit
and how the latter is set up in a service rack.
The purpose is to illustrate how you can
easily and effectively dismantle and assemble
the machine in its basic modules.
Service work on a component level, for ex-
ample, the satellite / grinding drive belt, is
described in detail in respective chapters.
THE CHASSIS / FRAME UNIT
The chassis / frame unit is designed to carry,
control and manoeuvre the grinding unit,
which is attached by two shafts through the
lifting lugs.
DETACH THE GRINDING UNIT
1. Unplug the power cables for the planet-
ary motor (a) and the satellite / grinding
motor (b).
2. Remove the R-clip (c) from the lifting
shaft on both sides.
3. Hold on to balance the chassis / frame
unit (d). Pull out the lifting lug shaft (e)
×2
on both sides.
REMOVE THE PLANETARY DRIVE
UNIT
4. Remove the 4 planetary drive position-
ing bolts (f). Two on either side.
5. Lift off the planetary drive unit.