Table of Contents
Advertisement
System Configuration and Menu Options
W7B ASD Installation & Operation Manual
System Configuration and
Menu Options
Root Menus
The MON/PRG key is used to access the three root
menus of the W7B ASD: the Frequency Command
screen, the Monitor screen, and the Program
Frequency Command Screen
Frequency Setting
While operating in the Hand mode (Hand LED is
illuminated on the EOI), the running frequency of
the motor may be set from the Frequency
Command screen. Using the Rotary Encoder, enter
Commanded Speed
in the Local Mode
Operating Mode
Running Speed
User−Selectable Monitored
(See
Monitor Screen on pg.
The Panel Menu screen provides easy access to
the most common setup parameters. Panel Menu
changes will affect EOI-controlled ASD operation
32
Figure 23. Root Menu Mapping.
Figure 24. Frequency Command Screen.
{
{
{
{
Items
33)
screen. From either mode, press the MON/PRG key
to loop through to the other modes (see
In the event of a fault, the ASD displays the fault
screen and provides an on-screen indication of the
fault type. The Fault screen remains in the MON/
PRG screen rotation (see
Figure
source of the fault is removed and the ASD is reset.
the desired Frequency Command value, press the
Enter key and then press the RUN key. The motor
will run at the Frequency Command speed and may
be changed while running. The Frequency
Command screen is not displayed during an active
trip.
Alarm Display
Section (Under−
Current Alarm
Example Displayed)
only and is accessed by pressing the ESC key from
the Frequency Command screen.
https://www.toshiba.com/tic/
Figure
23).
23) until the
Advertisement
Table of Contents
