System Configuration And Menu Options; Root Menus - Toshiba G9 ASD Quick Start Manual

System Configuration and Menu Options

Root Menus

The Mode key accesses the three primary modes of the ASD: the Frequency Command mode, the
Monitor mode, and the Program mode. From either mode, press the Mode key to loop through to the
other two modes (see Figure 25). While in the Frequency Command mode, pressing the ESC key
toggles the menu to and from the EOI Command mode and the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text
will be displayed on the Frequency Command screen and on the LED Screen when active. Fault
information will be displayed via the Fault screen. See the G9 ASD Installation and Operation Manual
for more information on Alarms and Trips.
Note: EOI Command mode changes are effective for EOI control operation Only.
Figure 25. G9 ASD Root Menu Navigation.
Frequency Command Mode
Frequency Setting
While operating in the Local mode (Local LED is illuminated on the front panel), the running frequency
of the motor may be set from the Frequency Command screen. Using the Rotary Encoder, enter the
Frequency Command value, connect ST to CC, and provide a Run command (F and/or R) and then
press the Run key. The motor will run at the Frequency Command speed and may be changed while
running. See Figure 22. on pg. 27 and Operation (Local) on pg. 61 for more information on the Frequency
Command mode.
G9 ASD Quick Start Guide 29
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net