Table of Contents
Advertisement
ST Signal Selection
Program Terminal Input Special Functions
This parameter is used to set the operation of the Standby (ST) control
terminal or any terminal configured as the ST terminal.
Settings:
0 — Standard
1 — Always On
2 — Interlock with F/R Terminal
The setting ST-to-CC Required enables the ASD for operation so long as
the control terminal ST is connected to CC via a jumper, contact, or
other means.
The ST-to-CC Not Required setting allows the ASD to operate without
the ST-to-CC connection. The control terminal ST may be configured for
other functions.
The Interlock with F/R Terminal setting configures the F (Forward) and R
(Reverse) control terminals for the secondary function of Standby.
Closing a set of contacts to either F or R will cause the ASD to
accelerate the motor to the programmed setpoint of F or R. Opening the
F and R contact will disable the ASD and the motor will coast to a stop.
The control terminal ST may be configured for other functions.
https://www.toshiba.com/tic/
Direct Access Parameter Information
W7B ASD Installation & Operation Manual
Direct Access Number — F103
Parameter Type — Selection List
Factory Default — Standard
Changeable During Run — No
F103-F103
61
Advertisement
Table of Contents
