Fujitsu PRIMERGY PG-R1CK21 Manual page 48

Installing the server in the rack
1
Pull the slide rails toward the front until they click into place.
2
Attach the server in the inner rail.
1. Insert the server to install the
2. Slide the server towards the
3. Fix the inner rail and the server
3
Slide the server backward
to install it in the rack cabinet.
Hold the locks on the right and left of
the slide rail pressed and slide the
server even further into the rack.
48
ledge part in the ditch of the
inner rail on the server side.
back until the screw hole of the
attached inner rail is over-
lapped with the screw hole on
the server side.
with the M3 flathead screws.
(Fix each side with two screws)
CAUTION
• Be careful not to pinch your fingers or catch any clothing when sliding
the server into the cabinet. Failing to do so may cause injuries.
Inner rail
Server
Inner rail
Fix with the M3 flathead screw.
(Common two places in both sides)
Press up to release.