JVC FS-GD7 Service Manual page 11

3.1.4 Removing the power (single) board
(See Fig.13, 14)
• Prior to performing the following procedure, remove the side
panel (R)/(L) and the top panel.
(1) Disconnect the wire from connector CN901, CN902,
CN905 on the power (single) board.
(2) Disconnect the wire from connector on the amp board.
(3) Remove the two screws M attaching the power (single)
board.
(4) Disconnect the connector
(single) board from the amp board while moving it in the di-
rection of the arrow.
CN906 and CN907 on the power
CN901
Power (single) board
CN905
CN906
CN907
Fig.13
Rear panel
Power (single) board
Fig.14
CN902
Rear panel
Amp board
connector
M
CN907
CN906
M
(No.MB355)1-11