Yaesu FTM-6000R Advance Manual page 25

z Data cable "CT-167" (MDIN 10 pin ←→ MDIN 6 pin)
PKD (packet data input)
À
GND
Á
PSK （PTT）
Â
RX 9600 (9600 bps packet data output)
Ã
RX 1200 (1200 bps packet data output)
Ä
PK SQL (squelch control)
Å
TXD (serial data output [transceiver → PC])
Æ
RXD (serial data input [transceiver ← PC])
Ç
CTS (data communication control)
È
RTS (data communication control)
É
• Make sure to turn the power to the radio OFF before connecting.
• Refer to the TNC operating manual for instruction on connecting the TNC to a personal
computer.
• RF receive interference may occur because of noise occurring in the personal computer.
When signals cannot be received normally, keep the personal computer at a distance away
from the radio and use a photo-coupler and noise filter to connect.
z DATA communication baud rate settings
1. Press and hold the [F menu] key.
2. Rotate the DIAL knob to select [16 PKT.SPD] then press the DIAL knob.
3. Rotate the DIAL knob to select "1200BP" or "9600BP".
4. Press the DIAL knob to save the setting and return to normal operation.
This completes the packet communication settings.
When transmitting a large volume of packet data, the transmission time gets longer, and
the transceiver may heat up. When transmission continues for a long period of time, the
overheating prevention circuit will act to lower the transmit power output. When transmission
is continued further, transmission will be suspended automatically, and the transceiver will go
into the receive mode to prevent failure due to overheating. When the overheating prevention
circuit is activated and the radio goes into the receive mode, either switch the power OFF, or
wait in receive mode until the transceiver cools.
To the transceiver
To the TNC etc.
Brown PKD (packet data input)
À
Black thick wire GND
Á
PSK （PTT）
Red
Â
Orange RX 9600 (9600 bps packet data output)
Ã
Yellow RX 1200 (1200 bps packet data output)
Ä
Green PK SQL (squelch control)
Å
Blue TXD (serial data output [transceiver → PC])
Æ
Gray RXD (serial data input [transceiver ← PC])
Ç
White CTS (data communication control)
È
Black RTS (data communication control)
É
22