Troubleshooting - Sony RM-TP2 Operating Instructions Manual

Troubleshooting

If you experience any of the following
difficulties while using the commander, use
this troubleshooting guide to help you remedy
the problem. Should any problem persist,
consult your nearest Sony dealer.
Operation can not be done with the commander.
• When using the commander as a 2-way remote,
check that the amplifier/receiver and components
are connected correctly (page 20).
• The commander and component are too far apart.
• Make sure that there are no objects between the
commander and component.
• Make sure that the component's power is turned
on.
• The commander's transmitter/receiver section is
not pointed at the component.
• The commander's battery is exhausted. Recharge
the battery (page 5).
• There is an invertor system florescent light near
the commander or component. Please place away
from the florescent light.
• Make sure you have selected the correct remote
(component) on the commander.
• When you operate a non-Sony component, the
remote (component) may not function properly
depending on the maker and model of the
component.
When using the Sony amplifier/receiver, the
amplifier/receiver's functions and modes do not
correlate with the displays on the commander.
• The information of the amplifier/receiver is not
downloaded. Download the information (page
21).
The LCD does not appear.
• The LCD is not turned on. Touch the touch
panel.
• Contrast is too light or too dark. Adjust the
contrast (page 30).
The LCD shifts from the normal operating
position.
• Adjusting the position of the touch panel (page
31).
When a component is connected to the
amplifier/receiver with Control A1/A1
Auto Function does not work properly.
• Download the amplifier/receiver data (page 21).
Commands of components made by
manufacturers other than Sony do not function.
• When registering components made by certain
manufacturers, some commands may not
function. These keys are dimmed.
When using 2-way Sony amplifier/receiver, the
commander and the amplifier/receiver cannot
communicate.
• If the amplifier/receiver's command mode (IR
type) and the commander's command mode (IR
type) do not match, transmission is not possible
between the commander and the amplifier/
receiver.
appears in the screen.
• 2 way communication error occured.
• When using the commander as a 2-way remote,
check that the amplifier/receiver and components
are connected correctly (page 20).
• The commander and component are too far apart.
• Make sure that there are no objects between the
commander and component.
• Make sure that the component's power is turned
on.
• The commander's transmitter/receiver section is
not pointed at the component.
• The commander's battery is exhausted. Recharge
the battery (page 5).
• There is an invertor system florescent light near
the commander or component. Please place away
from the florescent light.
• Make sure you have selected the correct remote
(component) on the commander.
E appears in the screen.
• The battery is running out. Recharge the battery.
cord,
GB
35