Table of Contents
Advertisement
Addit ional
Inform at ion
22
Downloaded from:
https://www.usersmanualguide.com/
Troubleshoot ing
If you experience any of the following difficulties while
using the remote, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
The rem ot e does not f unct ion.
, Point the remote at the remote sensor
receiver.
, Remove any obstacles in the path between the
remote and the receiver.
, Replace all the batteries in the remote with new
ones, if they are weak.
/ If the receiver's COMMAND MODE and the
remote's COMMAND MODE do not match,
transmission is not possible between the remote
and the receiver.
, Make sure you select the correct function on the
remote.
, When you operate a programmed non-Sony
component, the remote may not function properly
depending on the model and the make of the
component.
The com ponent nam es appearing in t he f unct ion
list do not correspond t o t he jacks on t he
receiver./The sound f ield list does not appear.
, The remote has not been initialized. Turn on the
receiver, point the remote at the receiver, and press
the SOUND FIELD, FUNCTION, or SUB button on
the remote (see page 3).
The SOUND FIELD but t on does not w ork.
, If the receiver has the 5.1CH (/DVD) INPUT jacks,
the SOUND FIELD button becomes inoperable
whenever you select the component connected to
these jacks.
E appears in t he display w indow of t he rem ot e.
, The batteries are running out. Replace all the
batteries with new ones.
The f unct ion nam es t hat appear in t he display
w indow s of t he receiver and t he rem ot e are
diff erent .
, Select the correct function using the remote.
When t he CD player, t ape deck, or M D deck is
connect ed t o t he receiver via CONTROL A1/A1
jacks, Aut o Funct ion does not w ork properly.
, Reprogram the remote (see page 16).
" 5.1CH" cannot be select ed f rom t he f unct ion list
even t hough t he receiver has 5.1CH (/DVD) INPUT
jacks.
, A communication error has occurred. Point the
remote towards the receiver and select "5.1CH"
from the function list again.
on the
Advertisement
Table of Contents
