Sony RM-TP2 Operating Instructions Manual page 28

Learning the commands of other
remote commanders (continued)
To program the IR code to the USER
RESERVE KEYS
1
Perform steps 1 to 5 of "To program an
IR code to the preset operation keys"
(page 26), then in step 6, select one of
the USER RESERVE KEYS you want to
program the IR code.
The LEARN screen appears.
Selected key
Name input buttons
2
Touch LEARN.
"Please Send Signal." appears. Perform step
3 within 30 seconds after the mark starts
blinking.
3
Press the appropriate button on the
remote control to send the remote
control code.
Press the button more than 1 second. When
this commander receives the remote control
code and the learning is successful, "This
key has a code." appears, and a mark (x)
appears in the upper right corner of the key.
GB
28
Message window
Command key
4
Touch EXIT.
5
Touch .
6
Touch USE in the pull-down menu.
The commander returns to the operation
mode.
To cancel learning
Touch CANCEL in step 2.
To clear the learned code
After step 3, touch CLEAR. "Clear?" appears.
Then, touch "YES". The learned code is
cleared.
Tip
• You can test the USER RESERVE KEYS. Touch
"TEST" after "This key have code." appears in step
3. The learned code is sent from the commander,
and if correct, the corresponding operation is
performed.
• You can make a name of up to 14 characters for the
USER RESERVE KEYS. Touch the name input
buttons as displayed to enter the name.
• To ensure the proper learning, we recommend using
new batteries in the remote to be learned.
Notes
• Normally, each remote (component) has 8 USER
RESERVE KEYS. However, depending on the
signals of the codes being learned, it may not be
possible for the commander to store codes for all
USER RESERVE KEYS.
• Some remote control codes cannot be learned.
Using a command that has
been learned
Select the key which has learned the command.