Kit Mounting; Final Procedures - Siemens MAMMOMAT 3000 Repair Instructions

2 - 4

Kit mounting

1.
locking ring/D
Fig. 5 Kit mounting
2.
3.

Final procedures

1.
2.
3.
4.
5.
6.
7.
8.
9.
MAMMOMAT 3000
Service
Coat the outside of the locking pawl with general purpose grease. Attach the lever
assembly to the holder with the new spring, the new locking pin and the new
locking rings (Fig. 5).
Check the surface of the large ring, on which the pawl slides during rotation of the
"flying wing". If rough spots are found, use a fine abrasive cloth to smoothen the
surface.
Coat lightly with general grease the contact area between the locking pawl and the
large ring on which the pawl slides during rotation of the "flying wing".
Fasten the new holder loosely with new screws.
Turn the swivel arm to 0°.
Fit the rotation stop screw.
Fit the screws for the ring. Make sure that the object table have the same
inclination as before the ring was removed.
Tighten the screws for the holder.
Check the operation of the lever for both "flying wing" positions.
Fit the bellow.
Fit the compression unit.
Fit the covers.
locking pin/C
spring/B
lever assembly/A
(locking pawl)
holder/E
SPB7-230.091.10
Rev. 01 02.00
Procedure
Page 4 of 4 Siemens-Elema AB
SPS-UD
2
2
Solna, Sweden