Description - Siemens SINAMICS S120 Operating Instructions Manual

Description

The option L34 (output-side circuit breaker) can be used to disconnect the motor terminals
from the converter.
This option is pre-wired and installed in a separate cabinet.
A description of the option is provided in the S120 Cabinet Modules Equipment Manual.
A script can be used for automatic parameter assignment in STARTER.
For automatic parameterization of option L34 (output-side circuit breaker), the script
"output_side_circuit_breaker_V1_2.xml" is provided on the customer DVD supplied with the
device.
Note
Script version
Script version V1.2 "output_side_circuit_breaker_V1_2.xml" was valid when these instructions
were being created.
If a newer script version is on the customer DVD provided, please use this version.
To run the script, all the following steps must be carried out in the completed project.
Free function blocks used
The following "free function blocks" are used in the script, and must not already be in use in
the project:
• MFP 0
• AND 0
• NOT 0
• OR 0
• PDF 0
Option L34 parameterizing the circuit breaker on the output side
Operating Instructions, 03/2021, A5E02914106A
2
11