Configuration; Front Panel Controls; Power Led; Network Led - Siemens SISTORE AX4 User Manual

Configuration

3 Configuration
3.1

Front Panel Controls

3.1.1

Power LED

3.1.2

Network LED

3.1.3

Backup LED

3.1.4

Camera Buttons (1 to 4)

14
Siemens Building Technologies
Fire & Security Products
NOTE:
Your DVR should be completely installed before proceeding. Refer to paragraph 2
Fig. 18 DVR front panel.
Many of the buttons on the front panel have multiple functions. The following
describes each button and control. Take a few minutes to review the descriptions.
You will use these to initially set up your DVR and for daily operations.
NOTE:
A separate Alarm button is not provided. Pressing any keys on the front panel resets alarm output
including the internal buzzer when the alarm is activated. However, when you are in the menu or PTZ
mode, you have to exit the menu or PTZ mode first to reset alarm output.
The Power LED is lit when the DVR is On.
The Network LED is lit when the unit is connected with RAS (Remote
Administration System) either via Ethernet or modem.
The Backup LED is lit when data is being backed up using the USB port.
Pressing the individual camera buttons will cause the selected camera to display
full screen. They are used to enter passwords. The camera buttons also function
in the PTZ mode. Pressing
zooms out in the PTZ mode.
CAMERA 2
the PTZ camera in the PTZ mode.
camera in the PTZ mode.
zooms in in the PTZ mode, and pressing
CAMERA 1
is used to control near focus of
CAMERA 3
is used to control far focus of the PTZ
CAMERA 4
SISTORE AX4_EN.doc
09.2004