Expansion Cards; Procedure For Expansion Card Installation - AMD Geode LX800 User Manual

NOTE! When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 166MHz, use only DDR333-compliant DDR
Modules. When this motherboard operate at 133MHz, most system will not even
boot if non-compliant modules are used because of the strict timing issues, if your
SDR Modules are not DDR333-compliant, set the DDR SDRAM clock to 133MHz
to ensure system stability.
2-5

Expansion Cards

WARNING! Turn off your power when adding or removing expansion cards or other system
components.
motherboard and expansion cards.

2-5-1 Procedure For Expansion Card Installation

1. Read the documentation for your expansion card and make any necessary hardware or
software setting for your expansion card such as jumpers.
2. Remove your computer's cover and the bracket plate on the slot you intend to use.
3. Align the card's connectors and press firmly.
4. Secure the card on the slot with the screen you remove above.
Plug the golden
figure into the
slot
Failure to do so may cause severe damage to both your
12
Press down
firmly