Honeywell X-618 Installation Manual page 30

Public address system

Hide thumbs Also See for X-618:

Table of Contents

Insert cable into monitor input terminal (8P) and fasten screws.

Insert cable into monitor input terminal of the X-DCS3000.

Install end-of-line supervision modules in cables. When there are many modules at one line,

connect them one by one and combine with loudspeaker end-of-line respectively.

Use screws to secure modules on wall.

Caution!

Each DLC bus on the X-DCS3000 cannot exceed more than 5 devices.

Connecting the Loudspeakers

The DCS can be directly connected to loudspeakers. The following steps describe this process:

Schematic Diagram of the X-DCS3000 Connection to the X-EOL

Table of Contents

X-dcs3000