Honeywell X-618 Installation Manual page 24

Public address system

Hide thumbs Also See for X-618:

Table of Contents

Insert the power amplifier input wiring terminal of the installed audio output cable into the

DCS PA audio input port, as shown in Figure 20 and Figure 14.

Figure 14 Schematic Diagram of the X-DCS3000 1070V Audio Input Wiring Terminal Installation

Carefully check the input and output cables of the DCS that connect to the amplifier,

ensuring the channels are correct.

Cover the power amplifier terminal with the protective terminal cover and tighten the

screws, as shown in Figure 15. This same operation applies to the DCS terminal and

related protective cover.

Figure 15 Schematic Diagram of the Protective Audio Input Terminal Cover

Figure 13 Schematic Diagram of the Audio Output Wiring Terminal Installation

Table of Contents

X-dcs3000