Honeywell X-618 Installation Manual page 21

HN-PTT (Optional) has to be selected instead of removable gooseneck microphone.
Caution:
Space of 1U (1U=44.45mm) should be reserved for cooling.
•
Blind disks are recommended to seal up the space in the front of cabinet.
•
Connecting the X-618 System Components
This section describes the connections between the following X-618 system components:
Connecting the Sound Source Equipment to the DCS
•
Connecting the DCS to the DA
•
Connecting the Dry Contacts (Optional)
•
Connecting the Noise Detector(Optional)
•
Connecting the loudspeaker
•
Connecting the DCS and NRI to the NPM
•
Connecting the Sound Source Equipment to the DCS or NRI
Connect the external sound source equipment to the DCS or NRI units.
The sound source connected to the DCS will be used for broadcasting in this devices' zones .The
sound source connected to the NRI will be used for broadcasting in all the zones of the X-618
system.
Connecting the X-DCS3000 to the Sound Source Equipment
For the X-DCS3000 Digital Integrated System Manager, there are 3 local auxiliary audio input
interfaces, in which interface 1 uses the RCA port, and interface 2 and 3 use the XLR port to send
a balanced or non-balanced signal from the microphone and sound console. For audio input 1, use
cable to connect the audio output and the X-DCS3000 to input 1. When connecting input 2 and 3 to
the external audio source, pay attention to the connection of interface pin. If it is necessary to use
these 2 ports introduce a non-balanced signal, short circuit the cool end with grounding wire.
Figure 8 X Diagram of X-DCS3000 Connecting the Sound Source Equipment
15